Skip to content

Driver

MAX22200 Driver

A C++20 driver for the Analog Devices MAX22200 and MAX22200A octal solenoid and motor drivers. It starts the chip with the datasheet's procedure, switches channels with one 8-bit write (one transfer per switch), programs HIT and HOLD in milliamps or percent, and reads the faults, on any MCU.

Quickstart API guide Source on GitHub

The driver has no platform code. You give it a small class that moves bytes and drives CMD and ENABLE; it does the rest: the programming procedure, the two-phase register access, the unit conversions, the read-back of every register at start-up, and the fault registers of both parts.

Octal solenoid and motor driver MAX22200 Analog Devices
Function
Eight push-pull half-bridges, 200 mΩ, up to 1 A RMS each; HIT then HOLD per channel
Regulation
Current (CDR, 7-bit, IFS from RREF, low side) or voltage (VDR, PWM duty in 1 % steps)
Configurations
Low side, high side, parallel pairs, full bridges for latching valves and DC motors
Diagnostics
OCP, open load, HIT current not reached, plunger movement, overtemperature, UVLO, SPI clock count
Interface
SPI mode 0, up to 10 MHz; a command byte with CMD high, then 8 or 32 bits; ENABLE, FAULT, TRIGA/TRIGB
Supply
VM 4.5 V to 36 V; logic inputs 6 V absolute maximum, 1.2 V high

What you get

  • One object per chip. MAX22200<YourPort> takes a reference to your port and does no I/O until EnsureInitialized(). See API guide.
  • Errors you can act on. Every call returns Result<T> with an Error such as Bus, ChannelsActive or DeviceReset. See API guide.
  • Datasheet codes, checked. Config{} holds the reset values of STATUS and every channel; the conversions refuse a current that would round to the unregulated code and a HIT time that would round to "forever". See Drive modes.
  • A fast hot path. Switching is one 8-bit write, one transfer after another switch; a read-back is there per call when you want it. See API guide.
  • Zero-overhead portability. The port is a CRTP class checked by a concept: the bus, CMD and ENABLE and a delay, plus optional FAULT-pin and logging hooks found at compile time. See Porting.
  • No heap, no exceptions, no RTTI. The host tests build with -fno-exceptions -fno-rtti. See Contract.
  • Tested without hardware, and honest about it. Host tests and a fuzzer run the driver against a protocol model of the chip; nothing is verified on hardware yet. See Status and limitations.

Datasheet

Document Revision Get it
Datasheet: MAX22200/MAX22200A 36V, 1A Octal Integrated Serial-Controlled Solenoid and Motor Driver (Analog Devices 19-100531) 1, 2025-03 vendor page

Written against these revisions; the SHA-256 of each file is in docs/datasheets.yml. Where each part of the driver is in the datasheet: Datasheet map.

Where to go next

  • Quickstart


    Wire the chip, write the port, open a valve in about 20 lines.

  • Hardware


    Pins, bus settings, timing and power.

  • Contract


    What the driver promises, what it needs, threading and errors.

  • API guide


    Start, switch, configure, read faults and handle errors, task by task.

  • Porting


    Implement the port for your MCU.

  • API reference


    Every class and member, generated from the headers.