Skip to content

Changelog

What changed in each release of the driver. Entries under Breaking need source changes in code that used the affected API.

[Unreleased]

Added

  • DYNAMIXEL bus-master driver: protocol 1.0 and 2.0 over a half-duplex UART, through a UART port you write.
  • Ping, Read, Write, Reg Write, Action, Factory Reset, Reboot, Clear, Control Table Backup, Sync Read, Sync Write, Fast Sync Read, Bulk Read, Bulk Write and Fast Bulk Read, with one DeviceReply per servo.
  • Control tables for 47 model numbers in 9 families, typed register access, ReadFeedback(), indirect addresses and baud schemes.
  • Reply search that skips noise, echo and late packets; LineFault and EchoMismatch for wiring faults.
  • A torque-off stop that is never refused, even when the input flush fails, and is sent three times when no answer can confirm it; Reboot() is sent the same way; destructive instructions behind Config::allow_destructive.
  • DisableTorqueAt(): the same stop for a servo whose family is not in the catalogue.
  • Typed calls and the stop refuse a family that does not speak the bus protocol, sending nothing.
  • Host example, ESP32 example (UART in RS-485 half-duplex mode, not verified on hardware), two fuzz targets with corpora.