|
DYNAMIXEL Driver 0.1.0
API reference
|
Protocol 1.0 error flags (the error byte of a status packet). More...
Variables | |
| constexpr uint8_t | kInputVoltage |
| Input voltage out of the configured range (condition). | |
| constexpr uint8_t | kAngleLimit |
| Goal position outside the angle limits (command fault). | |
| constexpr uint8_t | kOverheating = 0x04 |
| Internal temperature above the limit (condition). | |
| constexpr uint8_t | kRange = 0x08 |
| An instruction value out of range (command fault). | |
| constexpr uint8_t | kChecksum |
| The instruction's checksum was wrong (command fault). | |
| constexpr uint8_t | kOverload |
| Load beyond what the torque limit controls (condition). | |
| constexpr uint8_t | kInstruction |
| constexpr uint8_t | kCommandFaults |
| Flags that mean the instruction was not carried out. | |
| constexpr uint8_t | kConditions |
| Flags that report the servo's condition, not the instruction. | |
Protocol 1.0 error flags (the error byte of a status packet).
|
inlineconstexpr |
Goal position outside the angle limits (command fault).
|
inlineconstexpr |
The instruction's checksum was wrong (command fault).
|
inlineconstexpr |
Flags that mean the instruction was not carried out.
|
inlineconstexpr |
Flags that report the servo's condition, not the instruction.
|
inlineconstexpr |
Input voltage out of the configured range (condition).
|
inlineconstexpr |
Undefined instruction, or Action without Reg Write (command fault).
|
inlineconstexpr |
Load beyond what the torque limit controls (condition).