What the BMP581 needs from the SPI bus (sections 5.2.1, 5.5, table 18). A port and a board configuration check their settings against these with static_assert (handbook KB-CPP-123).
More...
|
| constexpr uint8_t | kSpiMode = 0 |
| |
|
constexpr bool | kMsbFirst = true |
| | Each byte is clocked most significant bit first (figures 8 to 11).
|
| |
|
constexpr uint32_t | kMaxClockHz = 12'000'000 |
| | Highest SCK frequency with VDDIO at or above 1.62 V and C_bus up to 80 pF (table 4, f_spi).
|
| |
|
constexpr uint32_t | kMaxClockLowVoltageHz = 7'000'000 |
| | Highest SCK frequency below VDDIO 1.62 V with C_bus up to 40 pF (table 4, f_spi_lowv).
|
| |
| constexpr uint32_t | kMinCsHighNs = 80 |
| |
| constexpr uint32_t | kCsSetupNs = 40 |
| |
|
constexpr uint32_t | kCsHoldNs = 40 |
| | Last SCK edge to CSB high, the CSB lag time (table 18, T_hold_csb).
|
| |
|
constexpr bool | kContinuousWord = false |
| | false: SCK may pause between the bytes of one frame while CSB stays low (section 5.5).
|
| |
What the BMP581 needs from the SPI bus (sections 5.2.1, 5.5, table 18). A port and a board configuration check their settings against these with static_assert (handbook KB-CPP-123).
◆ kCsSetupNs
| constexpr uint32_t bmp581::spi::kCsSetupNs = 40 |
|
inlineconstexpr |
CSB low to the first SCK edge. Table 18 gives only the CSB lag time; the same value is assumed here (not verified on hardware).
◆ kMinCsHighNs
| constexpr uint32_t bmp581::spi::kMinCsHighNs = 80 |
|
inlineconstexpr |
Shortest CSB high time between two frames: the idle time after a write or a read access (table 18, T_wr_idle and T_rd_idle).
◆ kSpiMode
| constexpr uint8_t bmp581::spi::kSpiMode = 0 |
|
inlineconstexpr |
SPI mode 0 (CPOL 0, CPHA 0); the chip also accepts mode 3, chosen by SCK at the CSB falling edge (section 5.5).