|
BMP581 Driver 0.1.0
API reference
|
What the BMP581 needs from the I2C bus (sections 5.6, 6.2.3, table 4). A port and a board configuration check their settings against these with static_assert (handbook KB-CPP-123).
More...
Variables | |
| constexpr uint8_t | kI2cAddress = 0x46 |
| 7-bit address with SDO low (section 5.6). SDO must not float on I2C. | |
| constexpr uint8_t | kI2cAddressSdoHigh = 0x47 |
| 7-bit address with SDO high (section 5.6). | |
| constexpr uint32_t | kMaxClockHz = 1'000'000 |
| Highest SCL frequency: fast mode plus, with C_bus below 100 pF (table 4, f_i2c). | |
| constexpr uint32_t | kMinClockHz = 100'000 |
| Lowest SCL frequency (table 4, f_i2c). | |
| constexpr bool | kRepeatedStart = false |
What the BMP581 needs from the I2C bus (sections 5.6, 6.2.3, table 4). A port and a board configuration check their settings against these with static_assert (handbook KB-CPP-123).
|
inlineconstexpr |
false: the chip keeps the register address across a STOP, so a read may use a repeated START or a STOP and a START (section 5.6.2, figures 15 and 16). The driver always calls WriteRead().